WHEELS
14
14.5.3
Removing the brake disc of the front brake
14.5.4
Installing the brake disc of the front brake
14.5.5
Changing the front wheel bearing
-
Check the wheel bearing for damage and wear.
If the wheel bearing is damaged or worn:
-
Change the front wheel bearing.
-
Clean and grease the shaft seal rings
I
Long-life grease
(ili)
p. 221)
-
Insert the spacers.
-
Position the front wheel and insert the wheel spindle.
✓ The brake linings are correctly positioned.
-
Mount and tighten screw(!}.
Guideline
I
Screw, front wheel spindle
-
Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
-
Remove the motorcycle from the lift stand.
-
Pull the front brake and compress the fork powerfully a few times.
✓ The fork legs straighten.
-
8.
Tighten screws
Guideline
I
Screw, fork stub
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the front wheel.
Main work
-
O.
Remove screws
Take off the brake disc.
Main work
-
Clean the contact surface of the brake disc.
-
Position the brake disc with the label facing outward. Mount and tighten
O.
screws
Guideline
Screw, front brake disc
Finishing work
-
Install the front wheel.
(Ii!:!
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the front wheel.
(ili)
p. 87)
O
and contact surface
I
M20x1.5
(ili)
p. 10)
(�
p. 10)
(�
p. 86)
M6
14 Nm
(10.3 lbf ft)
p. 86)
(ili)
p. 10)
(ili)
p. 86)
87
of the spacers.
6)
I
I
35 Nm (25.8 lbf ft)
I
1
Nm (11.1 lbf ft)
1
5
Loctite
243
®
™