Table of Contents
Advertisement
SHOCK ABSORBER, SWINGARM
9
9.18
9.19
Removing the heim ·oint
Condition
The damper has been disassembled.
-
Measure the inside diameter on both ends and in the middle of the damper car
tridge.
Damper cartridge
Diameter
If the measured value is greater than the specified value:
-
Change the damper cartridge.
-
Check the damper cartridge for damage and wear.
If there is damage or wear:
201402-10
-
Change the damper cartridge.
-
Check the heim joint for damage and wear.
If there is damage or wear:
-
Change the heim joint.
-
Measure the diameter of the piston rod.
Piston rod
Diameter
If the measured value is less than the specified value:
-
Change the piston rod.
-
Measure the run-out of the piston rod.
Piston rod
I
Run-out
201403-10
If the measured value is greater than the specified value:
-
Change the piston rod.
-
Check the piston rod for damage and wear.
If there is damage or wear:
-
Change the piston rod.
-
Check the piston rings for damage and wear.
If damage or a bronze-colored surface is visible:
-
Change the piston.
201404-10
Condition
The shock absorber has been removed.
-
Clamp the shock absorber in the vise using soft jaws for protection.
-
Remove the collar bushing of the heim joint.
I
Pin (T120)
(�
-
Turn the shock absorber and remove the second collar bushing of the heim joint.
s 50.08 mm (S 1.9716 in)
� 17.95 mm(� 0.7067 in)
I
s 0.02 mm (s 0.0008 in)
p. 231)
52
Advertisement
Table of Contents
