Table of Contents
Advertisement
20
LUBRICATION SYSTEM
Adding engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
I
0
�
Checking the engine oil
Warning
Danger of scalding
-
Wear suitable protective clothing and safety gloves.
-
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
-
Remove the oil filler plug
-
Add the same engine oil that was used when the motor was changed.
I
Engine oil (SAE 1 0W/50)
•
Info
I
For optimal performance of the engine oil, do not mix different types of
engine oil.
If appropriate, change the engine oil.
401955-10
m
-
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning
result in unconsciousness and death.
-
-
-
Start the engine and check that it is oil-tight.
ressure
Engine and gear oil get very hot when the motorcycle is ridden.
Hazardous substances cause environmental damage.
Main work
-
Remove screw
I
0
-
Position the special tool. Mount and tighten the banjo bolt.
Guideline
I
Banjo bolt
I
Oil pressure adapter (77329006000)
-
Connect the pressure tester without the T-piece to the special tool.
I
Pressure tester (61029094000)
-
Check the engine oil level.
401095-01
O
with the O-ring from the clutch cover.
(ll!:!l
p. 220)
Exhaust gases are toxic and inhaling them may
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running
the engine in an enclosed space.
O.
(ll!:!l
(llill
p. 227)
(llill
p. 188)
I
M10x1
I 8 Nm (5.9 lbf ft)
p. 230)
191
Advertisement
Table of Contents
