Adjusting The Play Of The Steering Head Bearing - Husqvarna FC 250 2015 Repair Manual

6
FORK, TRIPLE CLAMP
6.28

Adjusting the play of the steering head bearing

-
Press in the new bearing race all the way using a suitable tool.
-
Pull off bearing (s).
Remove seal ring retainer.
-
Remove O-ring.
-
Grease the new O-ring and mount with seal ring retainer.
-
Press on the new bearing with a suitable tube as far as it will go.
G01808-10
Finishing work
-
Install the lower triple clamp.
-
Install the front fender.
-
Install the start number plate.
-
Install the front wheel.
-
Check that the wiring harness, cables, and brake and clutch lines can move freely
and are routed correctly.
-
Check the steering head bearing play.
-
Remove the motorcycle from the lift stand.
-
Mount the handlebar cushion.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the handlebar cushion.
Main work
-
Loosen screws
-
Loosen and retighten screw (s).
Guideline
I
Screw, top steering head
-
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
-
Tighten screws
Guideline
I
Screw, top triple clamp
-
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
-
Check the steering head bearing play.
-
Remove the motorcycle from the lift stand.
-
Mount the handlebar cushion.
(l!!l p. 32)
(0 p. 82)
(0 p. 83)
(!!:! p. 86)
(0 p. 33)
(0
(!!:! p. 10)
O. 8.
Remove screw
I
M20x1.5
O.
8.
M8
(0 p. 33)
(0
p. 10)
112 Nm (8.9 lbf ft)
17 Nm (12.5 lbf ft)
17 Nm
Loctite ® 243
(12.5 lbf ft)
p. 10)
35
™