Changing The Front Brake Fluid - Husqvarna FC 250 2015 Repair Manual

Table of Contents

Advertisement

16
BRAKE SYSTEM

Changing the front brake fluid

Warning
Skin irritation
Brake fluid causes skin irritation.
-
Keep brake fluid out of the reach of children.
-
Wear suitable protective clothing and safety glasses.
-
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
-
Consult a doctor immediately if brake fluid has been swallowed.
-
Rinse the affected area with plenty of water in the event of contact with the skin.
-
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact with the eyes.
-
If brake fluid spills on to your clothing, change the clothing.
Warning
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Use only clean brake fluid from a sealed container.
Hazardous substances cause environmental damage.
-
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
-
Cover the painted parts.
-
Remove screws
-
Remove cover
-
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill
with fresh brake fluid.
Bleed syringe (50329050000)
Brake fluid DOT 4
-
Mount bleeder cover
I
Bleeder cover (00029013005)
Connect the bleeding device.
I
Bleeding device (00029013100)
-
Open shut-off valve
Info
I
Follow the operating instructions of the bleeding device.
-
Ensure that the inflation pressure is correctly set at pressure gauge f). If neces­
sary, adjust the inflation pressure at pressure regulator@).
Guideline
I
Inflation pressure
O.
8
with membrane.
(0
p. 225)
(ll!;!
p. 220)
@).
(0
p. 223)
(ll!;!
p. 223)
C,.
I
2 ... 2.5 bar (29 ... 36 psi)
108

Advertisement

Table of Contents
loading

This manual is also suitable for:

F2101o1F2175o1Fc 250 2014

Table of Contents