Checking The Engine Oil Level; Changing The Engine Oil And Oil Filter, Cleaning The Oil Screens - Husqvarna 701 Enduro 2023 Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.2
18.3
108

Checking the engine oil level

S01051-10

Changing the engine oil and oil filter, cleaning the oil screens

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Drain the engine oil while the engine is at operating temperature.
H01066-10
Condition
The engine is at operating temperature.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Main work
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before
checking the level.
The engine oil must be between marking
B
ing of the oil level viewer.
»
If the engine oil level is below the
–
Add engine oil. (
»
If the engine oil level is above the
–
Correct the engine oil level.
Preparatory work
–
Remove engine guard. (
Main work
–
Position an appropriate container under the engine.
–
1
Remove filler plug with the O-ring.
A
and mark-
B
mark:
p. 111)
A
mark:
p. 65)