Powering On The Detector For The First Time - Thermo Scientific Surveyor UV Plus Hardware Manual

Powering On the Detector for the First Time

Thermo Scientific
Table 5. Optional flow cells for the UV/Vis detector
Flow cell type
Kel-F™ bio cell
3 mm semi-prep
6 mm analytical
High-pressure microbore
Titanium bio cell
3 mm microbore
10 mm analytical
(standard on SRVYR-UV1)
6 mm microbore
Cuvette holder
High pressure standard
50 mm LightPipe
Most of the flow cells listed in
(P/N 60053-40005). The 50 mm LightPipe flow cell (P/N 803237) requires the LightPipe
flow cell cover (P/N 60053-40004). The high pressure microbore flow cell requires the
microbore flow cell cover (P/N 60053-40006).
After you have installed the flow cell, the detector is ready to be powered on.
 To power on the detector for the first time
1. Ensure that the power switch at the front of the unit is in the Off position (released or out
position).
IMPORTANT If you are using a previous version of the LightPipe flow cell that has
natural PEEK end caps, make sure the flow cell cover is in place before turning the
power on. When the instrument is powered on, it performs its Start-up diagnostics.
Ambient light can affect these diagnostics.
IMPORTANT Install the flow cell cover, which minimizes thermal fluctuations,
before you use the detector for data acquisition.
2. Attach the power cord to the power entry module on the back panel of the detector and
connect it to the power source.
3. Turn the power on by pushing the power button in to engage it.
Path length (mm)
6
3
6
2
6
3
10
6
N/A
6
50
Table 5 require the standard flow cell cover
Surveyor UV/Vis Plus Detector Hardware Manual
2
Powering On the Detector for the First Time
Volume (μL) Part number
9.0 9550-0103S
4.5 9550-0101S
9.0 9550-0100S
0.25 9550-0150-01S
9.0 9550-0197S
1.2 9550-0053S
15 9550-0234S
5.0 9550-0265S
N/A 9550-0263S
9.0 9550-0267S
10 803237
Installation
23