Connecting the 5-Connector System Interconnect Cable
Thermo Scientific
To connect the 5-connector interconnect cable
1. To connect the autosampler, plug the A/S connector into the left, 8-pin socket on the
back panel of the autosampler. See
Figure 14. Back panels of the Surveyor stack, showing the 5-connector interconnect cable
MS
Detector
M/S
Autosampler
MS Pump
Interconnect cable
2. To connect the pump, do one of the following:
• To connect the Surveyor LC Pump Plus, plug the connector identified by the blue
sticker with the text LC PUMP to the 8-pin receptacle on the back panel of the
pump. Look for a blue label with the text LC PUMP above the receptacle.
• To connect the Surveyor MS Pump Plus, plug the connector identified by the yellow
sticker with the text MS PUMP to the 8-pin receptacle on the back panel of the
pump. Look for a yellow label with the text MS PUMP above the receptacle.
3. To connect the UV/Vis detector, plug the DET connector into the left, 8-pin socket on
the back panel of the detector.
Figure
14.
Detector
DET
A/S
LC Pump
To
MS detector
Surveyor UV/Vis Plus Detector Hardware Manual
2
Making the Back Panel Connections
Solvent platform
Detector
(back panel)
Autosampler
(back panel)
Surveyor MS
Pump Plus
(back panel)
Installation
17