Installing Reel Driven Optional Dual Sprocket - MacDon FlexDraper FD2 Series Installation Instructions Manual

3.3 Installing Reel Driven Optional Dual Sprocket

With the optional dual sprocket, the operator can switch from high torque to high speed for operating in light crops at
increased ground speed.
1. Rotate chain tensioner (A) until both holes are visible in the
slot on the motor mount plate.
NOTE:
Some parts in the illustration have been removed or made
transparent for clarity.
2. Remove bolt (B) from the upper hole.
3. Rotate the wrench upwards to fully lower chain
tensioner (A).
NOTE:
Some parts in the illustration have been removed and some
made transparent for clarity.
4. Remove chain tensioner (A) from the upper hole on the
motor mount.
5. Install chain tensioner (A) in the lower hole on the motor
mount plate and secure it with (B).
6. Retrieve sprocket (MD #273689), six bolts (MD #320192),
and sprocket tool (MD #273594) from the kit.
215318
INSTALLATION INSTRUCTIONS
Figure 3.6: Chain Tensioner – View from Sprocket Side
Figure 3.7: Chain Tensioner – View from Sprocket Side
10
Revision B