4. Remove four bolts (A).
5. Remove cover (B) and deflector (C).
Installing the Driven Deflector
Follow these steps to replace the driven rotary deflector:
1. Position new deflector (C) on spindle so that it clears
accelerators (D).
2. Install cover (B) and secure with four bolts (A).
3. Tighten bolts.
4. Remove block of wood (if used).
Removing the Driveline Deflector
Follow these steps to replace the driveline deflector:
1. Lower the header fully.
2. Shut down the engine and remove the key.
3. Open cutterbar doors.
Doors, page
30.
169455
MAINTENANCE AND SERVICING
See Section
5.5 Cutterbar
Figure 7.39
Figure 7.40
130
Rev. E