Table of Contents
Advertisement
Restore Configuration
Restores the backup file created in "Backup Configuration" and applies it to the EM card.
IMPORTANT:
Executing the apply command reboots the EM card. If two EM cards
are installed, both cards are rebooted. While rebooting, a bridge feature
and SNMP feature are stopped. Accordingly, the connection via
management LAN of CPU blades and switch module is temporarily
disconnected. In addition, system monitoring by NEC ESMPRO
Manager is temporarily disabled. If a timeout error occurs, connect
them again after the active EM has rebooted.
NOTE:
works normally. If the standby EM is being activated or faulty, the
"apply" command cannot be executed.
Wait for a while until the standby EM becomes ready.
If the standby EM is faulty, remove it before executing the "apply"
command.
Configuration Backup File
When you click the [Browse] button, a dialog to select a file appears. Select a backup file to restore
from this dialog.
When two EM cards are installed, check if the standby EM
-
255
-
Advertisement
Table of Contents
