NEC N8405-019 User Manual page 271

Others
Specify the time to automatically turn off the backlight of SIGMABLADE monitor. Use this page to
specify the external syslog server used to transfer the EM syslog.

SIGMABLADE Monitor Backlight Off Delay
Specify the time in minutes.
 Syslog Server Support
Set this item to "Enable" when transferring the EM syslog to external syslog server. The
default setting is "Disable".

Syslog Server IP Address
Specify an IP address of external syslog server when "Enable" is specified for "Syslog
Server Support". The default value is "0.0.0.0".
NOTE:
intend to transfer the EM syslog to an external syslog server, be sure to
start the syslog server before starting the EM. If the syslog server is not
started when the EM attempts to write syslog to the syslog server, the
syslogd command is aborted and no syslog is collected. This restriction
is not applied to EM firmware revision 05.xx or later.

Language
Specify the language used in SNMP trap message and E-mail alert to be sent. Select a
language from the pull-down menu.
NOTE:
If you are using EM firmware revision 04.xx or earlier and
NEC ESMPRO Manager uses the language specified here.
- 251 -