Table of Contents
Advertisement
NOTES:
By clicking the [Reset] button, values in this page will be returned
to the value before any changes have been made.
If you set secondary target device, specify the same value as
primary target device for [iSCSI Name] in [Initiator Configuration].
For the devices marked with (*1), the following parameters can be
specified for 2nd Target.
– IP Address in Initiator Configuration
– Subnet Mask in Initiator Configuration
– Gateway in Initiator Configuration
– Primary DNS in Initiator Configuration
– Secondary DNS in Initiator Configuration
– IP Address in Target Configuration (only when MPIO Mode is
set to Disabled)
– TCP Port in Target Configuration (only when MPIO Mode is set
to Disabled)
– iSCSI Name in Target Configuration (only when MPIO Mode is
set to Disabled)
For the other parameters, the same values as primary target device are
used.
NOTES:
For the features marked with (*1), they can be applied to the following
devices.
CPU Blade
CPU Blades listed below does not support this feature:
120Bb-6, 120Bb-m6, 120Bb-d6, 140Ba-10, B140a-T, B120a,
B120a-d, B120b-Lw, B120b, B120b-d, B120b-h
Riser Card
Riser cards listed below support this feature:
N8403-062(F), N8403-063(F), N8403-064(F), N8403-081(F),
N8403-082(F), N8403-083(F)
Option cards for additional slot (I/O card)
Option cards listed below support this feature:
N8403-049(F), N8403-051(F), N8403-065(F), N8403-067(F),
N8403-084(F), N8403-085(F)
Features marked with (*2) has no effect if UEFI is selected for the Boot
Mode.
-
191
-
Advertisement
Table of Contents
