Table of Contents
Advertisement
Backup of EM Firmware
Creates a backup file of EM firmware in the USB memory connected to the USB port of the Blade
Enclosure.
When you select [3: Backup FW] on [EM Firmware Sub] menu, the confirmation message as shown
below is displayed.
Backup FW OK?
Y/N
Press [] or [] button to move cursor horizontally to switch selection between "Y" and "N".
To cancel backup, put the cursor on "N" and press the [Enter] button. The screen goes back to [EM
Firmware Sub] menu without changing the setting.
To execute backup, put the cursor on "Y" and press the [Enter] button.
If the old backup file exists in USB memory, the confirmation message as shown below appears.
Overwrite?
Y/N
Press [] or [] button to move cursor horizontally to switch selection between "Y" and "N".
To cancel backup, put the cursor on "N" and press the [Enter] button. The screen goes back to [EM
Firmware Sub] menu without changing the setting.
To execute backup by overwriting the current firmware, put the cursor on "Y" and press the [Enter]
button.
The following screen is displayed while backup is being executed.
Backuping FW
Upon completion of backup, the LCD displays the results.
When backup completed successfully:
OK
When backup failed:
Error
The following message is displayed if the USB memory is not installed.
Install the USB memory in the USB port of the Blade Enclosure.
USB Memory
Not installed
- 306 -
Advertisement
Table of Contents
