Table of Contents
Advertisement
Notes
The value set in CFG_EXPRESS_PASSWORD is encrypted and stored. Accordingly, you may not
edit it. To change password, use the "setdsl" command as described in "Command Reference".
If you have changed the value set in CFG_DSG_PASSWORD, delete values following
"CFG_DSG_PASSWORD= ", and reboot the EM card. This sets the default password "guest" in the
EM card. After that, you can set a new password by using the "setdsl" command.
If NEC DianaScope and NEC ESMPRO Manager Ver.5 or later are not used, set
CFG_DSG_ENABLE to "0" (Disable), and specify "0.0.0.0" for both CFG_DSG_IP1 and
CFG_DSG_IP2.
Notification of configuration change is made in the following cases:
CPU blade, switch module, and/or PSU was installed or removed.
The status of EM card was changed (from Standby to Active).
The rack name, Blade Enclosure name, and/or CPU blade name was changed.
- 66 -
Advertisement
Table of Contents
