Table of Contents
Advertisement
Change Password for SIGMABLADE Monitor
When you click the [SIGMABLADE Monitor] tab, the following screen appears.
Enable Password
Specify whether to use the password for SIGMABLADE monitor or not.
If you select [Disable] and apply it, you can skip the password entry when operating the
SIGMABLADE monitor.
Enter Password
Old Password
Enter the current password.
New Password
Enter the new password.
New Password (confirmation)
Enter the new password for confirmation.
NOTE:
actual characters.
Apply
When you fill in each password field properly and click the [Apply] button, the EM card compares
the password entered in the old password field with the registered password. If they match, the two
new passwords are compared. And if they match, the password is registered as a new password.
If they do not match, the new password is not registered and the old password is retained.
The new password becomes valid after the EM card is rebooted (both EM cards, if installed). If you
are using EM firmware revision 14.xx or later, the change is applied immediately, and thus you do
not need to reboot the EM card.
The characters you have typed are displayed as "" to hide the
-
273
-
Advertisement
Table of Contents
