Table of Contents
Advertisement
Setting Chassis Management Data
Specifies the name of Blade Enclosure in which the EM card is installed, and the rack name on
which the Blade Enclosure is installed. In addition, the name of switch module to be installed in the
same Blade Enclosure in which the relevant EM card is installed. Specify those names with up to 31
ASCII characters.
NOTE:
value stored in the Blade Enclosure is used instead. When you specified
the Blade Enclosure name and the rack name, those names are stored in
the Blade Enclosure.
When you specified the switch module name, that name is stored in the
switch module.
Write the configuration file in the format as shown below.
Rack Name
-----------------------------------------------------------------
[RW_RACK_SECTION]
CFG_RACK_NAME = "<Rack Name>"
-----------------------------------------------------------------
<Rack Name>: rack-name
<Example>
-----------------------------------------------------------------
[RW_RACK_SECTION]
CFG_RACK_NAME = "Rack-A"
-----------------------------------------------------------------
NOTES:
NEC ESMPRO Manager accepts single-byte characters including
alphanumerics, period, hyphen, and underscore. Accordingly, it is
recommended to use these characters for specifying a name.
If the Blade Enclosures Inter Connect is used, they share the rack
name. The rack name set in a Blade Enclosure will also be set in the
other Blade Enclosures.
If CFG_RACK_NAME is not contained in
[RW_RACK_SECTION] or "" is specified for CFG_RACK_NAME,
the value stored in the Blade Enclosure is loaded.
To specify "" (blank) in CFG_RACK_NAME, use the OSD (On
Screen Display).
Rack name must be specified if you want to use auto detect feature
or auto report feature of ESMPRO Manager.
If no rack name or Blade Enclosure name is specified, the
-
35
-
Advertisement
Table of Contents
