Table of Contents
Advertisement
setdsl
Outline
Activates the menu to set linkage with NEC DianaScope and NEC ESMPRO Manager
Ver.5 or later.
Syntax
setdsl
Parameter
None
Details
– Changes the user password used when the EM card in linked with NEC DianaScope
and NEC ESMPRO Manager Ver.5 or later. The password must be 16 characters or
less.
– Disables or shows the status of linkage with NEC DianaScope and NEC ESMPRO
Manager Ver.5 or later. The shipping default value is "Enabled". The connection from
the NEC DianaScope and NEC ESMPRO Manager Ver.5 or later to the EM card is
enabled. If NEC DianaScope and NEC ESMPRO Manager Ver.5 or later are not used,
set this item to "Disabled".
This command can be executed in the active EM card only.
Notes
This command can not change the linkage feature from Disable to Enable. To change
from Disable to Enable, use the web console(see page 234).
If you change the setting by using this command, be sure to apply the changes by
executing the apply command (see page 83). If you are using EM firmware revision 14.xx
or later and you have changed the user password only, you do not need to execute the
apply command.
- 94 -
Advertisement
Table of Contents
