Example Configuration - Sip Trunks - NEC XN120 Manual

Example Configuration – SIP Trunks
This example shows two XN120 systems, connected via an Ethernet network. The extension numbers are
different on both systems and the users on each system should be able to dial each other by using their
extension numbers alone. SIP Trunks will be used, along with F-route to simplify dialing.
The configurations are based on default systems (ie. Cold Start) and assumes that a VOIPU (no
daughterboard) is installed in CN1 (Slot 5). A system restart is required after applying these changes.
Program XN120 A
10-03-02 (Slot 5)
10-12-01 192.168.001.010
10-12-02 255.255.255.0
10-23-01 (Sys 1) 1
10-23-02 (Sys 1) 192.168.001.020
10-23-04 (Sys 1) 3
10-28-01
10-28-02 systema
10-28-04 200
11-01-01 (Dial 3) 3 Digits, Type 6
11-01-02 (Dial 2) <default>
11-02-01 <default>
14-05-01 (Trk4-7)
21-19-01
22-02-01 (Trk4-7)
22-09-01 (TRG 2)
22-11-02 (Table1) <default>
22-11-02 (Table2) <default>
44-02-01 (Table1) 3
44-02-02 (Table1)
44-02-03 (Table1)
44-05-01 (F-Rte1)
84-05-01 (Slot 5) 192.168.001.011
84-13-28
XN120 Voice Over IP Card Guide
XN120 B
All VOIPU Ports to Type 1:SIP
192.168.001.020
255.255.255.0
1
192.168.001.010
2
xn120.co.uk
systemb
300
<default>
3 Digits, Type 6
300, 301, 302, etc
2
200, 201, etc 300, 301, etc
3: DID (for all time modes)
2
300
301
2
2: F-Route table
1
2
192.168.001.021
2: G729
Example Configurations
Comments
Assigns ports as SIP
System IP Address
Subnet mask
Enables this table entry
IP Address of remote system
Digits to associate with remote system
SIP Domain Name
SIP Host Name
UserID for system
Uses F-Route to handle calls to numbers
beginning with 2 or 3
Change extension numbers on Sys. B
Put VOIPU trunks into own trunk group
Match CLI to extension number
Set trunks to DDI mode
Set number of received DDI Digits
Define DDI translations for incoming calls
Dialled digits
Routes to F-route tables (PRG44-05)
Specifies F-Route table 1
Uses Trunk Group 2 (VOIPU Trunks)
IP Address for VOIPU card
Set voice CODEC to G.729
31