NEC N8405-019 User Manual page 210

Target Configuration
Parameters for 1st Target

iSCSI Name
Specify the name of target.
Use numeric character ('0' to '9'), lower-case alphabet character ('a' to 'z'), hyphen ('-'),
period ('.'), and colon (':').
Up to 127 characters are allowed for devices listed in (*1), and 222 characters for other
devices.
See "Note" described later for devices marked with (*1).

IP Address
Specify the IP address of target.

TCP Port
Specify the TCP port number of the target. Available values are ranging from 1024 to
65535.

Boot LUN
Specify the LUN of the target. Available values are ranging from 0 to 255.
 Mutual CHAP ID (*1)
Specify the Mutual CHAP ID with single-byte characters including alphanumerics, period,
colon, and hyphen. Up to 127 characters are accepted.

Mutual CHAP Secret
Specify the Mutual CHAP Secret with single-byte characters including alphanumerics,
period, colon, and hyphen. Characters ranging from 12 to 16 are accepted.
If 2nd Target is enabled, specify its parameters similary to the 1st Target.
When using the secondary target device, click [Next] to open [iSCSI Secondary Configuration]
screen. Provide settings in the same way as [iSCSI Primary Configuration].
The following parameter is included in [iSCSI Secondary Configuration].

MPIO Mode (*1) (*2)
Specify [Enabled] when using MPIO Mode.
When MPIO Mode is enabled, all the Target Parameters specified for Primary
Configuration are used for Secondary Configuration (values you have specified in iSCSI
Secondary Configuration are ignored).
- 190 -