Printhead Lamp; Encoder Speed; Purge Button; Purge Count - Dover markem-imaje 5200 Service Manual

SECTION 4 Diagnostic Tools
2.4.13
2.4.14
2.4.15
2.4.16
2.4.17
4–14

Printhead Lamp

Parameter Options: On, Off
Access Level: Read–3; Write–3
The Printhead Lamp parameter indicates the state of the amber
LED on the printhead.

Encoder Speed

Access Level: Read–3
The Encoder Speed parameter indicates the speed of the conveyor/
product. The units of measure are established at Machine Setup.

Purge Button

Parameter Options: On, Off
Access Level: Read–3; Write–3
The Purge Button parameter indicates the current state of the
printhead purge button and provides the ability to purge the
printhead remotely.

Purge Count

Access Level: Read–3
The Purge Count parameter counts the number of manual purges.
Note that printhead firmware 2403049E or later is needed to support
this feature.

Jet Test Button

Parameter Options: On, Off
Access Level: Read–3
The Jet Test parameter indicates the current state of the printhead
jet test button.
0855855eng 6/08