Safety Labels; Location Of Safety Labels - Dover markem-imaje 5200 Service Manual
Hide thumbs
Also See for markem-imaje 5200:
- Operation manual (67 pages) ,
- Instruction manual (37 pages) ,
- Installation and setup manual (136 pages)
Table of Contents
Advertisement
4.3
Safety Labels
4.4
Location of Safety Labels
0855855eng 6/08
SECTION 1 General Information
High Voltage
To prevent injury from electrical shock, remove the power cord from
the electrical outlet before performing troubleshooting or repair.
Electronic troubleshooting must be performed by personnel trained
to troubleshoot electrical circuits.
Hot Surfaces
To prevent injury from burns, be careful not to touch the jet array
surface or hot ink directly. Wear protective eyeglasses when working
with hot ink.
Protective Earth
This label identifies a protective earth point.
Earth
This label identifies an earth point.
FRONT
REAR
1–7
- Quick Links:
- Error and Warning Messages
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the markem-imaje 5200 and is the answer not in the manual?
Questions and answers
How turn up heat on printer heads? On the Markem 5400 printer
The heat on the printheads of a Markem 5400 printer is controlled by the ink line heater circuit and internal parameters. There is no direct user-adjustable setting to increase the heat. The ink line heater operates automatically, and the Printhead Voltage, which affects jet firing and heat, is pre-programmed and can only be changed by Markem-Imaje service personnel.
This answer is automatically generated