VTI Instruments Corp.
Rackmount Installation Option (P/N: 70-0370-102)
The rackmount installation option includes all the parts necessary to mount an EX1200 to the front
and rear of a standard test rack.
Required Tools
1) #2 Phillips screwdriver
2) 5/16" wrench or socket
Parts List
Item#
1
2
3
4
5
6
7
8
9
Assembly Procedure
1) Place the chassis on a protected work surface with its input connectors facing front.
2) Using a #2 Phillips screwdriver, install the rack ears (P/N: 41-0494-010) on the front of the
EX1200 using four (4) 6-32 x 3/8" flat head Phillips stainless steel screws (P/N: 37-0173-037)
for each rack ear. Note that the "Optional Mounting Locations" in Figure 2-11 allow the
EX1200 to be installed in a rack either flush or recessed.
3) Next, attach the unit support brackets (P/N: 41-0494-020) to the EX1200 using two (2) 6-32 x
3/8" pan head Phillips SEMS screws (P/N: 37-0028-037) for each bracket (see Figure 2-11).
4) Place the rear rack support brackets (P/N: 41-0494-021) on the inside of the unit support
brackets installed in Step 3 and loosely secure them using two (2) 8-32 x 3/8" pan head
Phillips SEMS screws (P/N: 37-0073-037) and two (2) KEPS hex nuts (P/N: 37-0200-832).
Loosely installing the hardware will allow the rear support bracket to adjust to the proper
length once installed in a rack.
5) Place the EX1200 in the desired rack slot and secure the front rack ears with hardware
provided with the rack. Once the front bracket are secured, slide the rear support brackets so
that they can be attached to the rack as well. After securing the rear support brackets, tighten
the screws and KEPS nuts installed in Step 4.
52
Qty
Description
2
Bracket, Rack Ear, EX1267/68/69
2
Bracket, Rack Ear, Support, EX1267/8/9
2
Bracket, Rack Ear, Rear Unit, EX1267/8/9
2
Handle, 0.25 dia x 1.25 H X 4.0 L, 8-32, Aluminum, Black
8
Screw, 8-32 x 1/2" Flat Head Phillips, 82°, Stainless
8
Screw,6-32 x 3/8", Flat Head Phillips, 82°, Stainless Steel
4
Screw, 6-32 x 1/4" Pan Head Phillips, Sq Cone SEMS Zinc
4
Screw, 8-32 x 3/8" Pan Head Phillips, Sq Cone SEMS Zinc
4
Nut, Hex, KEPS, 8-32 Steel/Zinc
VTI P/N
41-0494-010
41-0494-020
41-0494-021
37-0254-000
37-0129-050
37-0173-037
37-0028-025
37-0073-037
37-0200-832
EX1200 Series Preparation for Use
Need help?
Do you have a question about the Metek EX1202 and is the answer not in the manual?