Ex1200 Series Dmm Specifications - VTI Instruments Metek EX1202 User Manual

High-density switch/measure and control systems
Hide thumbs Also See for Metek EX1202:
Table of Contents

Advertisement

VTI Instruments Corp.
G
S
ENERAL
PECIFICATIONS
M
F
EASUREMENT
UNCTIONS
P
HYSICAL
Dimensions
C
OOLING
Recommended airflow
E
NVIRONMENTAL
Operating temperature
Operating altitude
Operating humidity
Storage temperature
Storage altitude
Storage humidity
Shock and vibration
W
-
T
ARM
UP
IME
L
F
INE
REQUENCY
L
IMITS
R
B
S
EADING
UFFER
TATISTICS
T
RIGGER
Type
M
N
-D
AXIMUM
ON
ESTRUCTIVE
S
IGNAL
HI or Sense HI to LO
HI or Sense HI to Guard
HI or Sense HI to Chassis (GND)
LO or Sense LO to Guard
LO or Sense LO to Chassis (GND)
Guard to Chassis (GND)
Maximum common mode voltage
Using external probe
Current input protection
NOTE
All accuracy specifications on the following pages are after 30 minute warm-up with trigger auto-delay,
range auto-delay, and auto-zero ON.
, is the temperature at which the DMM was calibrated as reported by the DMM's internal
T
Cal
temperature sensor.
The DMM is calibrated at approximately T
calibration log file for the exact temperature)
20
EX1200 S
DMM S
ERIES
DC voltage (DCV), true rms AC voltage (ACV)
DC current (DCI), true rms AC current (ACI)
2-wire ohms (2W-R), 4-wire ohms (4W-R)
(8.6 in x 4 in x 0.6 in)
5.9 L/s (12.5 CFM) minimum
0 °C – 55 °C
10,000 ft (3,000 m) maximum
5% - 95% non-condensing @ 0°C - 30°C, 5% - 75% non-condensing @ 30 °C – 40 °C,
5% - 45% non-condensing @ 40 °C – 50 °C (per 3.8.2 of MIL-PRF-28800F Class 3)
-40 °C – 70 °C
15,000 ft (4,500 m) maximum
5% – 95%, non-condensing
Per 3.8.5 of MIL-PRF-28800F, Class 3
30 min
Manually set to 50 Hz or 60 Hz (default)
Programmable lower and upper limit values
Count, Minimum, Maximum, Average
Automatic or programmable delay
I
NPUTS
CAT-I I
L
NPUTS
IMIT
450 V
450 V
450 V
200 V
450 V
450 V
450 V
1.5 kV
3 A, 250 V fuse, externally accessible
= +32 °C ± 5 °C internal temperature (see the DMM
Cal
PECIFICATIONS
EX1200 Series Introduction

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Metek EX1202 and is the answer not in the manual?

Table of Contents