Precautions - Inspur NF5180M6 User Manual

9. Using an incompatible battery may cause explosion. When battery replacement is
required, please consult the manufacturer first, and choose batteries of the same
or equivalent type suggested by them. Do not disassemble, crush, puncture the
batteries or short circuit the external connection point, and do not expose them in
the environment over 60°C (140°F). Never throw batteries into fire or water. Please
do not attempt to open or repair the batteries. Dispose of used batteries properly.
Do not put waste batteries, circuit boards or other components that may contain
batteries with other wastes. For battery recycling, please contact the local waste
recycling center.
10. For independent cabinets, please install front and side stabilizers before installing
the equipment into the cabinet. For cabinets connected with other cabinets, please
install front stabilizers first. Failure to install the corresponding stabilizers before
installing the equipment into the cabinet may cause the cabinet to tip over,
possibly leading to personal injury. Hence, please do make sure to install
stabilizers before installing the equipment into the cabinet. After installing the
equipment and other components into the cabinet, only one component can be
pulled out from the cabinet through its sliding part at one time. Pulling out several
components at the same time may cause the cabinet to turn over, resulting in
serious personal injury.
11. Please do not move the cabinet on your own. Considering the height and weight of
the cabinet, the moving of the cabinet should be completed by at least two people.
Moving it without adequate, trained personnel could result in severe injury or
death.
12. It is prohibited to directly short-circuit the copper busbar. Please do not touch the
copper busbar when the cabinet is powered on.
13. This is a Class A product, and may cause radio interference. In such case, users
may need to take necessary measures to mitigate the interference.
1.2

Precautions

The following considerations may help avoid problems that could damage the
components or cause data loss, etc.
In the event of the following, please unplug the power plug from the outlet and

contact Inspur Customer Service:
The power cords or power plugs are damaged.
-
The products get wet.
-
The products have fallen or have been damaged.
-
Other objects have fallen into the products.
-
The products do not or cannot function normally even when you operate
-
according to the instructions.
If the system gets wet or damp, please follow steps below:

2