Precautions - Inspur NF5260FM6 User Manual

9. Always use the battery type recommended by the manufacturer or a similar
battery for replacement. Using an incorrect battery type may cause an
explosion. Never attempt to dismantle, squeeze or dismantle a battery or short
circuit the battery. Do not throw it into fire or water, or expose it to an
environment with a temperature above 60 °C. Ensure the used batteries are
properly and safely disposed of. Do not mix a used battery with a circuit board
with batteries or with other components and wastes. For information on
battery recycling, contact your local recycling agency.
10. Before installing devices on a stand-alone cabinet, install the front and side
leveling feet. For a cabinet connected to other cabinets, install the front
leveling feet first. Be sure to install the leveling feet before installing devices in
the cabinet to prevent the cabinet from tipping over to cause personal injury.
After devices and other components are installed in the cabinet, only slide one
component out of the cabinet at a time. Pulling out multiple components at a
time may cause the cabinet to tip over and result in personal injury.
11. Do not move the cabinet alone. At least two people are required to move the
cabinet.
12. Do not touch the copper busbar when the system is powered on. Do not short
circuit the copper busbar.
13. This is a "Class A" product, which may cause radio interference. You may need
to take adequate measures against its impact.

Precautions

Before using the product, please carefully read the following precautions to avoid
the issues that may cause component damage or data loss.
1. Disconnect the product's power cable from the power socket and contact Inspur
Customer Service under any of the following circumstances.
a. The power cable, extension cable, or power plug is damaged.
b. The product gets wet with water.
c. The product falls off or is damaged.
d. An object falls into the product.
e. The product does not work properly when the operating instructions are
followed.
2. If the system is exposed to moisture, follow the steps below.
a. Power off the system and devices. Disconnect their power cables, wait 10
to 20 seconds, and then open the chassis cover.
2