To Prepare For Operation; To Adjust The Supporting Legs; To Connect To Ac Power Supply - Rigol DS7000 Series Quick Manual

RIGOL

To Prepare for Operation

To Adjust the Supporting Legs

Adjust the supporting legs properly to use them as stands to tilt the oscilloscope
upwards for stable placement of the oscilloscope as well as betteroperation and
observation.
Figure 3 To Adjust the Supporting Legs

To Connect to AC Power Supply

This oscilloscope can accept100-240V, 45-440 Hz AC power supply. Please use the
power cord supplied with the accessories to connect the oscilloscope to the power
supplyas shown in the figure below. Whenthe oscilloscope is powered onand the
Power key at the lower-left corner of the front panel is blinking.
Power Cord Connector
Figure 4 To Connect to AC Power Supply
3
MSO2000A/DS2000A Quick Guide