Table of Contents
Advertisement
Selecting measurement mode
Procedure
1.
Press the MODE hard key.
2.
Select More (1/2) > Fiber Inspection.
Configuring test parameters
Selecting profile and tip
You can select analysis profiles and inspection tips from the list.
Procedure
1.
Press the MEASURE SETUP hot key.
2.
Press the Profile & Tip soft key.
The profile and tip pane appears.
3.
To select one of the pre-configured analysis profiles that match the PASS/FAIL criteria in the IEC
visual inspection standard, complete the following steps:
a.
Tap the drop-down list button for the Profile.
b.
Select the profile that you want to use, from the following choices:
–
–
–
–
–
–
4.
To select the inspection tip (optical settings) that you want to use, complete the following steps:
a.
Tap the drop-down list button for the Tip.
b.
Select one of the tips available to your selected profile, from the following choices:
–
–
5.
Tap the Apply button or press the Apply soft key to save and return to the previous state.
Setting preferences
You can set your preferences of auto center and QuickCapture button function. The QuickCapture
button is the small grey round button on the side of the microscope.
Procedure
1.
To set the function of the QuickCapture button on the side of the P5000i, toggle the Test Button
soft key and select the option from the following choices:
MM (IEC-61300-3-35)
Ribbon, MM (IEC-61300-3-35)
Ribbon, SM APC (IEC-61300-3-35)
SM APC (IEC-61300-3-35)
SM PC (IEC-61300-3-35)
SM UPC (IEC-61300-3-35)
NOTE
All of the profiles are factory set and cannot be edited or removed.
Standard Tips (with BAP1) and Simplex Long Reach (-L) Tips
Ribbon Tips and Ribbon Tips – Long Reach
NOTE
This setting allows you to select the best optical settings for the type of inspection tip
that is attached to your microscope probe.
Performing Fiber Inspection
JD780A Series Analyzers
563
Advertisement
Table of Contents
