5
O
PERATION
Selecting a wavelength
The sensitivity of the photo diode depends on the
wavelength. The wavelength setting of the device must
match the wavelength of the incoming signal to ensure a
correct reading.
To select a wavelength:
⇒ Press [λ] to select a new wavelength.
The value is shown in the lower left display pane:
selected wavelength
The wavelengths that can be selected by pressing this
key are an extract of those contained in the internal
wavelength table (λ-Table).
Note: See
„Editing the Lambda-Table", page 18
for
details of how to edit this table.
JDSU
cOPM-A1
25