Table of Contents
Advertisement
JD780A Series Analyzers
Procedure
1.
Press the SYSTEM hot key.
2.
Press the System Configuration soft key.
3.
Press the Remote Interface soft key and then do the following:
–
Select the LAN soft key and then press the App SW soft key.
–
Select the USB soft key and then press the App SW soft key.
Setting USBTMC mode
The USB Test & Measurement Class (USBTMC) is a standard for programmatic control of USB-based
test instruments that defines protocols used to send and receive messages. If you want to use the
USBTMC protocol to communicate with the instrument remotely, you can turn this TMC Mode on.
Procedure
1.
Press the SYSTEM hot key.
2.
Select System Configuration > Remote Interface > USB.
3.
Press the USBTMC soft key.
The confirmation dialog box appears.
4.
Press the USBTMC soft key again to confirm the mode change and reboot the instrument.
NOTE
After using the USBTMC mode, you may want to set this setting back to App SW if you
use JDViewer mainly for remote controlling your JD780A series.
Setting SCPI mode
You can use SCPI commands to control your JD780A series remotely.
Procedure
1.
Press the SYSTEM hot key.
2.
Select System Configuration > Remote Interface > LAN.
3.
Press the SCPI soft key.
NOTE
After using the SCPI mode, you may want to set this setting back to App SW if you use
JDViewer or JDRemote mainly.
Configuring LMF setting
The Local Maintenance Facility (LMF) setting is used in order to perform TX Calibration and TX Audit
on Motorola's CDMA/EV-DO BTS in the RF Power Meter mode. See "Appendix F – Motorola
CDMA/EV-DO LMF" on page 576 for more information.
Enabling Bluetooth connection
If your JD780A series has the Bluetooth Connectivity option installed with a license, you can use the
48
Getting Started
Advertisement
Table of Contents
