Table of Contents
Advertisement
JD780A Series Analyzers
3.
Do one of the following:
–
To let the instrument set the last measurement as a reference, complete the following steps:
a.
b.
NOTE
To set or release reference, you can also press and hold the physical round button on the
connected MP-series power meter for a few seconds until you hear a beep.
–
To set the reference manually, complete the following steps:
a.
b.
c.
Holding a measurement
Procedure
1.
To hold the measurement, press the HOLD hard key.
Measurement is paused and the text "Hold" appears.
2.
To resume the measurement, press the HOLD hard key again.
Measurement is resumed and the text "Hold" disappears.
560
Toggle the Relative Reference soft key and select Last.
Press the Reference Last soft key.
Toggle the Relative Reference soft key and select Manual.
Press the Reference Manual soft key.
Enter a value manually as you desire, and then press the Enter soft key.
Using Power Meter
Advertisement
Table of Contents
