Table of Contents
Advertisement
Measurement example
Figure 19
Route map measurement screen with GPS
Controlling a map
If you have loaded a sizable map that was created in JDMapCreator 1.2.0 or later, you can use the
Map Control feature that enables you to zoom into the map and view a specific area of interest in detail.
Procedure
1.
Press the TRACE/DISPLAY hard key.
2.
Press the Map Control soft key. This key is active only when you have loaded a sizable map.
3.
Do one of the following:
–
To zoom into an area of interest directly, complete the following steps:
a.
b.
c.
d.
–
To zoom into the center or zoom out from the center, complete the following steps:
a.
b.
c.
Loading and displaying raster data
If you have a set of raster data files generated through the ariesoGEO application, you can load and
overlay the data on your route map to help you check the signal quality and the strength of
interferences while driving toward the area of interest.
Toggle the Zoom to soft key and select Area.
The black rectangle appears on the map.
Press the Zoom In and Zoom Out soft keys, as you need, to decrease and increase
the selected area.
Move the rectangle by using the four arrow keys, as you need, to place it in a specific
area of interest.
Press the center of the rotary knob to zoom into the selected area. You can also press
the Zoom to soft key again to zoom into the selected area.
Toggle the Zoom to soft key and select Center.
Press the Zoom In and Zoom Out soft keys, as you need, to zoom in and zoom out.
Move the zoomed-in area by using the four arrow keys, as you need.
Using Spectrum Analyzer
JD780A Series Analyzers
87
Advertisement
Table of Contents
