Table of Contents
Advertisement
Indoor mapping does not necessarily need a GPS antenna.
Configure test parameters as described in the "Configuring test parameters" on page 415.
2.
3.
To load your map file, complete the following steps:
Plug in your USB drive that has a floor map or .mcf file type created in JDMapCreator. . If
a.
the JDMapCreator application on your computer is connected to the instrument via USB or
LAN, you can send a map file with a single layer to the instrument directly by using the
Send to EQP menu in JDMapCreator.
NOTE
The JDMapCreator converts and resizes any scanned floor plan or layout to fit onto your
instrument's display. JDMapCreator 1.2.0 or later can save a multiple-layered map,
providing x1, x2, and x4 views, as a sizable map file so that you can zoom in and out
after loading it.
b.
Press SAVE/LOAD hot key, and then select Load > Load Map.
See "Using load" on page 34 for more information.
4.
Press the MEASURE SETUP hot key.
5.
Press the Plot Point soft key, and then select the plot point option from the following choices:
–
To collect data/plot points automatically as you move around in a vehicle or outside, press
the GPS soft key and then toggle the Screen Mode soft key between Map and Full.
NOTE
With the Map setting, you can view only the collected points that can be seen within the
boundary of the loaded map. If a point is off the map, the instrument displays an arrow to
indicate the direction of the current location on the map and the distance from the center
to the location at the top of the screen.
With the Full setting, you can view all the collected points of the route without the loaded
map.
–
To collect data/plot points manually without a GPS antenna in an indoor environment, press
the Position soft key.
6.
Toggle the Plot soft key and select Start to start plotting.
7.
Touch directly on the screen or press the ENTER hard key to collect data and plot points on the
loaded map for the Position setting.
NOTE
For the Position setting, you can change the direction of the route with the arrow keys
and the distance with the rotary knob.
8.
Toggle the Plot soft key and select Stop to stop plotting.
9.
Press the SAVE/LOAD hot key to save the result.
See "Using save" on page 31 for more information.
NOTE
The instrument does not automatically save the collected data. It is recommended that
you save the result. Otherwise, you will lose all the collected data.
Setting limit for route map
You can set the thresholds for each test item.
Procedure
1.
Press the LIMIT hot key.
2.
Press the Excellent soft key to set its threshold.
3.
Enter a value, and then press the Enter soft key. You can also use the rotary knob.
Using TD-SCDMA Signal Analyzer
JD780A Series Analyzers
449
Advertisement
Table of Contents
