Table of Contents
Advertisement
NOTE
It is recommended that you select HSPA+ for RCDE testing.
4.
To set the S-CCPCH information of the system to be tested, complete the following steps:
a.
Press the S-CCPCH soft key.
b.
Toggle the S-CCPCH soft key between On and Off to enable or disable the S-CCPCH.
c.
Press the Spread Factor soft key, and then select the spread factor option: 4, 8, 16, 32, 64,
128, or 256.
d.
Press the Spread Code soft key to set the spread code.
e.
Enter a value by using the numeric keys.
f.
Press the Enter soft key.
5.
To set the PICH information of the system to be tested, complete the following steps:
a.
Press the PICH soft key.
b.
Toggle the PICH soft key between On and Off to enable or disable the PICH.
c.
Press the Spread Factor soft key, and then select the spread factor option: 4, 8, 16, 32, 64,
128, or 256.
d.
Press the Spread Code soft key to set the spread code.
e.
Enter a value by using the numeric keys.
f.
Press the Enter soft key.
6.
Optional. To set the threshold, complete the following steps:
a.
Press the Threshold soft key.
b.
Enter a value by using the numeric keys.
c.
Press the Enter soft key.
7.
Optional. Go to SAVE/LOAD > Save, and then select the save option from the choices available
for your measurement mode. See "Using save" on page 31 for more information.
Measurement example
Figure 66
Relative code domain error with WCDMA/HSPA+ signal analyzer
Using WCDMA/HSPA+ Signal Analyzer
JD780A Series Analyzers
173
Advertisement
Table of Contents
