Table of Contents
Advertisement
JD780A Series Analyzers
d.
Highlight your mobile device from the list by touching on the screen.
e.
Press the Pair soft key.
The pairing dialog box appears on your smartphone.
f.
On your smartphone, enter 0000 and then tap the OK button.
If pairing is successful, the status of your device on the list changes to "Paired".
4.
Make sure to set your smartphone as a slave by completing the following steps:
a.
On your smartphone, open the RANAdvisor TrueSite icon.
b.
Go to Settings > General.
c.
Tap the Automation Control Mode menu under Automation Control Options.
d.
Select the Local Bluetooth Control option.
e.
Tap Slave.
The application restart dialog box appears.
f.
Tap Continue.
The application closes itself.
NOTE
It is very important for you to set the local Bluetooth control option to Slave on the
RANAdvisor TrueSite app in order to give your instrument a control to collect necessary
data from the app over Bluetooth successfully.
Setting parameters on RANAdvisor TrueSite
To specify uplink measurement data that will be transferred to your instrument, you need to set map
display parameters of your choice on the RANAdvisor TrueSite application.
Procedure
1.
After you have paired and set your smartphone as a slave, open the RANAdvisor TrueSite icon
on your device again.
2.
Tap the (+) button at the bottom of the Home screen.
The Main Screen appears.
3.
Tap the Customization menu.
The Choose Operation menu box appears.
4.
Select Map Display Parameters > LTE Serving and Neighbor Parameters.
5.
Make sure to check the checkbox for the following two mandatory parameters:
–
Serving E-ARFCN
–
Serving Physical Cell-ID
NOTE
It is very important for you to select these two parameters to identify the Uplink Channel
Number, Cell ID, Group ID, and Sector ID.
6.
Select other parameters up to six from the list of parameters supported by the CellAdvisor
instrument. See "Appendix L – Supported map display parameters" on page 591 for more
information.
NOTE
As the RANAdvisor TrueSite app can transfer data of up to eight parameters at a time, it
limits you to select eight parameters in total: two compulsories and six electives. After you
have selected all eight parameters, the app blocks any further selection. In this case, you
need to uncheck any selected optional parameters in order to enable other optional
parameters.
7.
Tap the OK button and then the Back key to return to the Home Screen.
Performing RAN performance testing
After you have set the local Bluetooth control option and selected desired parameters on the app, you
need to connect your instrument to your smartphone via Bluetooth to enable data collection from
258
Using LTE - FDD Signal Analyzer
TM
Advertisement
Table of Contents
