Table of Contents
Advertisement
C
B
Turn the engine off, remove the key from the
ignition and disconnect battery prior to per-
forming this procedure.
To replace worn rollers:
1. With the machine turned off and parked in a safe
working area, follow steps 5-11 in the track
removal procedure on page 11-8 to expose the
sprocket for roller replacement.
2. Remove the bolt (A) holding the steel pins (B) and
rollers (C) in place. The pins and rollers will then
fall free from the sprocket.
3. Install the new rollers over the pins.
4. Slide the bolt back through the sprocket and pins
and tighten.
5. Repeat this procedure as necessary throughout
the sprocket.
6. Follow steps 10-14 in the track installation proce-
dure on page 11-10 to re-install the drive table and
prepare the machine for track tension adjustment.
7. Repeat steps 1-6 of this procedure on the other
side of the machine if necessary.
8. Perform the track tension adjustment procedure on
page 11-4 to complete the procedure.
Note: Terex recommends replacing external rollers as a set
to simplify inspection and maintain proper sprocket function.
Note: Internal pins should be inspected when replacing
rollers. Internal pins do not rotate during operation and may
experience uneven wear. If when replacing external rollers,
internal pins are worn on one side only and appear to be in
good condition otherwise, they may be rotated 180 degrees
from their original position and reused. Replace if worn to
less than 35% of original thickness.
Tilt-Up Canopy
A
The ROPS/FOPS approved canopy tilts up to allow
easier access while performing service work. It fea-
tures a gas spring assist and a brace mechanism to
hold it in place while tilted.
To raise the canopy:
1. Remove any attachment fastened to the quick
attach.
2. Raise the lift arms and secure with lift arm brace.
3. Remove the bolts at the base of the canopy that
fasten it to the chassis.
4. Remove the air pre-cleaner assembly (1) from the
machine.
5. Remove the two limb risers (2) from the machine.
6. Raise the canopy and watch to make sure the
lock-out brace falls into place.
7. Secure the canopy lock-out brace with the D-latch
pin (3) as shown.
The canopy is now secure.
Canopy
11-5
Compact Track Loader
11. Maintenance
3
2
1
2
Advertisement
Table of Contents
