Lift Cylinder/Tilt Cylinder Installation; Lift Cylinder/Tilt Cylinder Seal Kit Removal - Terex PT-30 Service Manual

Remove
bolt and
then pin
Figure 13-6
9. Remove the bolt and pin from the loader tower.
10. Again support the cylinder from the underside
then remove the lift cylinder from the machine.

Lift Cylinder/Tilt Cylinder Installation

1. To install the lift/tilt cylinder, reverse the removal
procedure.
2. Add removable locktite to all fittings.
3. Add grease to loader pin zerks to ensure
lubrication of bushings.
Lift Cylinder/Tilt Cylinder
Seals Removal
Table 13-2
Required Tools
Channel Lock Pliers
Bench Vice
Blade Type Screwdriver
Socket
Rubber Mallet
Lift Cylinder / Tilt Cylinder Seal Removal
Note: The procedures for removing seals on the lift
cylinders and tilt cylinders are similar, only the lift cylinder
procedure is described below.
13. Loader Disassembly and Assembly
Figure 13-7
1. Secure the cylinder into a vice and remove the
end gland by turning counter clockwise with
channel lock pliers. Be sure to have a container
to catch draining hydraulic fluid.
Figure 13-8
2. Remove the rod from cylinder by pulling
outward using both hands as shown.
Figure 13-9
3. Secure the rod in the bench vice as shown.
13-3
Compact Track Loader
End gland