Table of Contents
Advertisement
Chapter Overview
This chapter provides disassembly and assembly
procedures for the undercarriage assemblies.
Personal Safety
Improper or incomplete maintenance/repair of a Compact
Track Loader can be dangerous and may result in
machine damage, injury or death.
Do not attempt to perform any type of repair or
maintenance on a Compact Track Loader until you have
read and fully understood the information in this manual.
Refer to the Operation and Maintenance manual for
instructions regarding proper machine operation
techniques before operating any Compact Track Loader.
Prior to performing any type of service work on a
Compact Track Loader, read and understand
Chapter 1 (Product Safety) for personal safety
information.
Machine Preparation
Accidental machine starting can cause injury or
death to personnel working on a Compact Track
Loader.
As a precaution, disconnect the battery cables from
the battery terminals, tape the battery clamps and
remove the key from the ignition switch prior to
performing any service work on a Compact Track
Loader.
Place a "Do Not Operate" tag prominently on the
machine to inform personnel that the machine is
being worked on.
10. Undercarriage
Disassembly and
Undercarriage Disassembly
and Assembly Procedures
Disassembly and assembly procedures are provided
for the following undercarriage components.
•
Drive Sprocket
•
Drive Motor
•
Wheel Replacement
•
Track removal and installation (see Ch. 11)
Note:
Procedures
undercarriage components listed above. However, other
helpful information can be obtained from the machine
specific parts manual.
Sprocket Removal and
Installation
The tools required for sprocket removal and
installation are listed in Table 10-1. Use
manufacturer-recommended tools whenever
possible.
Table 10-1
Required Tools
Socket Wrench
Combination Wrench
Sprocket Removal
1. Remove the 7 bolts that fasten the bearing plate
to the drive table. (fig. 10-18,10-19)
10-1
Assembly
are
provided
for
only
those
Advertisement
Table of Contents
