Figure 12-32B
Sprocket Roller Installation
Figure 12-33
1. With the drive sprocket rotated to the desired
position, position the composite roller and steel
pin in the drive sprocket.
Figure 12-34
2. Insert the sprocket roller bolt from the rear.
Torque to 62 ft. lbs.
12. Undercarriage Disassembly and Assembly
Sprocket Removal and
Installation
The tools required for sprocket removal and
installation are listed in table 12-5 below. Use
manufacturer-recommended tools whenever
possible.
Sprocket Removal
Table 12-5
Required Tools
Socket Wrench
Sprocket Puller
1. Remove the sprocket bearing plate as described
on page 12-7.
Figure 12-35
2. Install the puller by positioning the push bolt into
the end of the sprocket shaft and then threading
the puller bolts into the holes in the fac e of the
drive sprocket. (fig. 12-35 & 12-36).
Figure 12-36
12-9
Compact Track Loader
Impact Driver
Puller holes