Mercedes-Benz Zetros 2020 Operating Instructions Manual page 167

remove jewellery and watches
R
keep items of clothing and hair, for exam-
R
ple, away from moving parts.
Only use oils which have been approved
!
for the vehicle and with the prescribed SAE
classification.
Do not add too much oil. If you add too
much oil, the engine or the exhaust system
could be damaged. Have excess oil
siphoned off.
You will find information about engine oils in
the "Service products" section (
Do not top up with the quantity of oil shown in
the on-board computer until the 4 symbol
appears in the display.
X
Park the vehicle on a level surface.
X
Apply the parking brake.
X
Switch off the engine.
X
Y
Open the bonnet (
X
Unscrew and remove cap :.
X
Top up the oil fill level shown in the display.
X
Replace and screw on cap :.
X
Close the bonnet.
Major assemblies
Checking the vehicle assemblies for
leaks
H
Environmental note
Improper handling of service products is
hazardous to the environment.
Y
page 146).
page 156).
Do not allow service products to enter the
sewage system, surface waters, ground
water or soil.
Check the vehicle assemblies for leaks regu-
larly. If fluid loss is identified, e.g. through oil
drops on the parking area, have the cause of
the fluid loss rectified at a qualified specialist
workshop.
Checking the anti-corrosion protec-
tion
Road salt has a corrosive effect. In winter,
!
wash the vehicle more frequently in order to
remove salt residue. Salt residues can oth-
erwise damage the anti-corrosion protec-
tion.
The cab is provided with body cavity protec-
tion and underbody protection.
X
Check the vehicle regularly for corrosion
damage, particularly the compressed-air and
hydraulic lines.
X
Have any damage to the factory-fitted anti-
corrosion protection rectified at a qualified
specialist workshop.
X
As a precautionary measure, spray the
underside of the vehicle with a wax-based
protective agent according to Mercedes-
Benz Specifications for Service Products
Sheet No. 385.1.
Batteries
Important safety notes
G
WARNING
Electrostatic build-up can lead to the crea-
tion of sparks, which could ignite the highly
explosive gases of a battery. There is a risk
of an explosion.
Before handling the battery, touch the vehi-
cle body to remove any existing electrostatic
build-up.
The highly explosive gas mixture is produced
when the batteries are being charged and dur-
ing the jump-starting procedure.
Maintenance
Z
165