Maintenance
5
5.1
General Maintenance
CAUTION
Under most conditions, the SVS100N requires very little maintenance.
The air inlet must be kept free from debris. Blow out or vacuum out dust accumulation
periodically.
As needed, repair or replace damaged or worn output cables and connectors.
All other servicing is to be performed by Authorized service personnel only.
Replacing DC Output Power Cables
Replacement cables may be purchased directly from your Authorized SVS100N dealer.
N
WARNING
To replace cables:
1. Remove the screws and open the front door of the SVS100N.
2. Locate the BMID Communication Terminal Blocks and DC Output Studs. Refer to Figure 5-1.
3. Disconnect the Communication Wires from their terminal block.
12876-W-03-01
Always disconnect and lockout/tagout power to the unit before
performing any maintenance.
Use only connectors and cable that are rated for the full continuous
current rating of the unit unless the output current of the unit has been
adjusted to a lower value.
Figure 5-1 DC Output Connections
SVS100N Operation/Maintenance Manual
35
Webasto Charging Systems, Inc.