Webasto PosiCharge SVS100N Operation And Maintenance Manual page 9

WARNING
 Do not install or place unit on, over or near combustible surfaces.
 Do not install unit near flammables.
 Do not block air intake or exhaust.
 Do not block or filter airflow to the unit (allow minimum of 18" clearance around unit).
 Ensure that the Battery Monitor/Identifier (BMID) is properly installed according to the BMID
installation instructions.
 Replace blown fuses only with same type and rating of fuse.
 Do not overload building wiring - be sure power supply system is properly sized, rated and
protected to handle this unit. Use only on circuits provided with the minimum wire size
specified in the installation section.
 Protective balusters should be installed where charging equipment location is subject to
damage from vehicle activity.
 To avoid shock hazard, only install cables approved by PosiCharge
 Do not subject the cable or coupler to damage or stress. Do not step on the coupler cable.
 Do not hang from the coupler cable.
 Do not disassemble the SVS100N.
 Only use metal conduit above ground.
Follow the National Electrical Code (NEC) and local codes. NEC and local codes take
precedence. If any instructions in this manual conflict with NEC or local codes, contact
Webasto Charging Systems, Inc. for further information.
12876-W-03-01
OSHA INSTRUCTION STD 1-11.4
OCTOBER 30, 1978
4. Action
"Battery charging" areas where power industrial truck batteries are
charged only—no maintenance is performed, batteries are not removed
from the trucks and no electrolyte is present in the area—are not subject
to the requirement of 29 CFR 1910.178 (g) (2). The charging areas shall
be in compliance with 29 CFR 1910.178 (g) (1), (8), (9), (10), (11) and
(12). Personal protective equipment shall be used when and where
required.
SVS100N Operation/Maintenance Manual
4
TM
for outdoor use.
Webasto Charging Systems, Inc.