Safety Instruction - Webasto PosiCharge SVS100N Operation And Maintenance Manual

2.2

Safety Instruction

CAUTION
BEFORE
YOU BEGIN
DANGER
 The unit must be grounded properly with a grounding conductor of size equal to or larger
than that recommended by local electrical codes or the installation section of this manual.
 Do not touch the uninsulated portion of the output battery connector or an uninsulated battery
terminal.
 Only qualified service personnel may remove the cover on the SVS100N. There are no user
serviceable parts inside. Refer all servicing to qualified service personnel. Opening the
system or attempted installation or repair by other than qualified service personnel voids the
warranty.
 Disconnect battery charger from input power and battery connections before installing or
servicing. Lockout/tagout input power according to OSHA 29 CFR 1910.147.
 Do not perform installation/service/repair work when in standing water.
 The SVS100N is designed to automatically stop a charge event to prevent arcing or burning
of the charger connections in the event of a hot disconnect.
 The charging cables must be sized for the full rated current of the SVS100N, and inspected
frequently for wear, cuts and abrasion. Do not use worn, damaged, undersized, or spliced
cable.
 The SVS100N battery connector is subject to normal wear and tear, and may be damaged by
misuse or abuse. Frequently inspect the connector for cracking, pitting of contacts, fraying of
wires or signs of connector fatigue. A damaged charging connector should be replaced
immediately.
12876-W-03-01
 Read all instructions and cautionary markings on the Industrial
PosiCharge
 Make sure you also read the IMPORTANT SAFETY
INSTRUCTIONS below.
 Be sure to leave these instructions with the installed unit for
future reference.
 Only qualified personnel should install, use or service this
charger.
 Read and understand these Manufacturer's instructions and
your employer's safety practices manual.
ELECTRIC SHOCK CAN KILL: Touching live electrical parts can
cause fatal shocks or severe burns. The battery terminals are always
electrically live, and the output circuit is live whenever the battery is
connected or being charged. The input power circuitry and internal
circuits are live whenever input power is on. An incorrectly installed or
improperly grounded charger is a hazard.
SVS100N Operation/Maintenance Manual
TM
(SVS100N) Assembly.
3 Webasto Charging Systems, Inc.