Panel To Wall - Adjustable Connection - tayco Cosmo Installation Manual

panel to wall - adjustable connection

1. Remove all the tiles on one side
of the panel.
2. Measure height of frame to be
mounted from floor to top of
frame. Mark this height on the
wall.
3. Place the adjustable connector
(Type 1, 2 or 3) against the wall
using the mark as a guide.
Check for plumbness.
4. Using a torpedo level, level the
adjustable connector with the
side of the frame.
5. Mark wall with a pencil through
the pre-drilled holes in the
adjustable wall connector.
6. Remove wall connector, then drill
wall through the markings. Insert
wall anchors.
7. Place the adjustable wall
connector back onto the wall,
line up the holes on both wall
and connector, then place the
#10 screws provided through
holes and tighten, using #2
Robertson long bit, (Figure 1).
8. Using the #2 Robertson long bit,
attach the 2 x 2-inches square
tubing onto the edge of the
frame, with #10 self tapping
screws, from the inside of the
frame, (Figure 2).
MARCH 2017
FIGURE 1
ADJUSTABLE WALL
CONNECTOR
FIGURE 2
TOP VIEW
TYPE 1
TYPE 2
TYPE 3
2 X 2-INCHES
SQUARE TUBING
#10 SELF
TAPPING SCREW
2 X 2-INCHES
SQUARE TUBING
cosmopolitan 45