Table of Contents
Advertisement
worksurface support installation - reinforcement bar
1. Turn the work surface upside
down and measure 6 inches
from the back and 1 1/2-inches
from each side of the work
surface; make marks on the
surface with a pencil.
2. Position the reinforcement
support according to the marks,
to be parallel to the back side of
the surface.
3. Screw the reinforcement bar on
the surface with 11/16-inch oval
head screws, then tighten
(Figure 1).
4. Turn around the work surface
and install it at its proper location
(see Worksurface Installation).
NOTE:
> Reinforcement bars are only
installed on surfaces longer than
48-inches (from 54 to 96-inches
long) that do not have underdesk
pedestals attached to them.
MARCH 2017
FIGURE 1
1 1/2-INCHES
6-INCHES
1 1/2-INCHES
REINFORCEMENT BAR
drill
#2 Robertson bit
tools & hardware needed
measuring
11/16" oval
tape
head screw
cosmopolitan 73
Advertisement
Table of Contents
