Table of Contents
Advertisement
door assembly - straight configuration
1. Make sure door is closed before
starting installation, (Figure 1).
2. Remove all the tiles on one side
of the panel.
3. Line up top of door frame with
the existing panels, either to the
left or to the right.
4. Using a #2 Robertson long bit,
insert the 1 1/2-inches tapping
screws into the holes on the
edge of the panel frame, which
will then protrude into the door
frame, (Figure 2).
5. Step on the metal threshold bar
to level off with the floor.
MARCH 2017
FIGURE 1
FIGURE 2
1 1/2-INCHES
TAPPING SCREW
METAL THRESHOLD BAR
cosmopolitan 36
Advertisement
Table of Contents
