Table of Contents
Advertisement
3. Remove all the tiles on one side
of each panel.
4. Rotate one panel to create a
120-degree angle.
5. Using a 6-inches hex key, install
the 25 mm or 1-inch hex screws
into the inside edge of the panel
frame; this will protrude into the 2
way 120 CONNECTORS,
(Figure 3).
6. Insert a piece of 1 1/2-inches
diameter sponge vertically so
that light will not protrude
through, (Figure 3).
7. Re-install the tiles previously
removed, if there is no panel to
install next to it.
NOTES:
> Do not re-install the tiles right
away, might need them off to
install next frames.
> Sponge to be inserted before last
panel is installed.
MARCH 2017
FIGURE 3
TOP VIEW
25mm HEX
SCREW
panel height (inches)
2 way, 120 connector
25mm hex screw
1 1/2-INCHES
SPONGE
37
45
2X
3X
8X
12X
torpedo level
drill
L-120-CONNECTOR
1 1/2-INCHES
SPONGE
25mm HEX
SCREW
hardware needed
53
61
69
77
85
3X
3X
3X
3X
4X
12X
12X
12X
12X
18X
tools needed
6" hex key
box wrench
cosmopolitan 26
Advertisement
Table of Contents
