stackable frame connection
1. Remove the tiles on one side of
the panel and the stackable
panel. The stackable panel
frame has two extrusions welded
on its sides. Insert these
extrusions into the top of the
base frame of panel that has to
be raised, (Figure 1).
2. Fasten the stackable frame panel
extrusions by the base frame of
the panel with a 25 mm or 1-inch
hex screw on each side. The
screws have to be inserted into
the holes provided from the
inside of the panel frame; use a
6-inches hex key to tighten,
(Figure 2).
MARCH 2017
FIGURE 1
STACKABLE PANEL
EXTRUSION
FIGURE 2
25mm
HEX SCREW
cosmopolitan 29