Table of Contents
Advertisement
panel assembly - cross configuration (cont'd)
3. Remove the tiles on one side of
each panel.
4. Rotate one panel to create a
90-degree angle.
5. Using a 6-inches hex key, install
the 25 mm or 1-inch hex screws
into the inside edge of the
panels; this will protrude into the
CROSS CONNECTORS,
(Figure 3).
6. For the third and fourth panels,
follow the same procedures as
stated above.
7. Insert a piece of 2 1/2-inches
diameter sponge vertically, so
that light will not protrude
through, (Figure 3).
8. Re-install the tiles previously
removed, if there is no panel to
install next to it.
NOTES:
> Do not re-install the tiles right
away, might need them off to
install next frames.
> Sponge to be inserted before last
panel is installed.
MARCH 2017
FIGURE 3
2 1/2-INCHES
SPONGE
TOP VIEW
25mm HEX
SCREW
panel height (inches)
cross connector
25mm hex screw
37
45
2X
3X
16X
24X
torpedo level
drill
CROSS
CONNECTOR
25mm HEX
SCREW
2 1/2-INCHES
SPONGE
hardware needed
53
61
69
77
85
3X
3X
3X
3X
4X
24X
24X
24X
24X
32X
tools needed
6" hex key
box wrench
cosmopolitan 22
Advertisement
Table of Contents
