Table of Contents
Advertisement
panel top mounted glaze installation (cont'd)
3. Check the glass if there are fast
caps on both sides of the plastic
gasket before inserting it into the
base extrusion, (Figure 3).
4. To align and secure glass/acrylic
into the base extrusion, insert the
1/4-20 x 1/4" set screws through
each of the holes on the sides of
the base extrusion using an allen
key driver. Tighten gently each
side until the glass/acrylic is
centered and secured, (Figure 4).
NOTE: DO NOT OVERTIGHTEN.
MARCH 2017
FIGURE 3
FAST CAP
FIGURE 4
drill
allen key
#2 Robertson bit
GLASS/ACRYLIC
FAST CAP
PLASTIC GASKET
FAST CAP
BASE EXTRUSION
PANEL
tools & hardware needed
#10-1x 1/2" self
1/4-20 x 1/4"
set screws
drilling screw
cosmopolitan 92
Advertisement
Table of Contents
